All receiver and controller outputs can specified or J1939 CAN bus.The standard receiver/controller units are NOT rated explosion proof and are typically installed in non hazardous electrical control equipment areas. Receiver/controller units are provided with antenna and coax cable for outside antenna mounting providing maximum operating range.

Explosion-proof electrical enclosures are available on request.There are some models of bulk plant wireless emergency shutdown system. These are;MODEL ASKFAX200-AC:Fixed-frequency remote E-Stop switch operates at 433MHz using two double A batteries.

Transmitter is energized only when E-Stop switch is activated. Battery test button shows a low battery flashing LED on the E-Stop switch as well as on the receiver/controller unit. The basic operating range is up to 1000ft.Daily E-Stop transmitter battery tests and scheduled Auto Control Cables battery replacement intervals are strongly recommended. The E-Stop transmitters and receivercontroller shut-down will NOT operate when the remote E-Stop transmitter batteries are exhausted.MODEL DSSF 100-AC: This wireless industrial remote control has direct sequences; spread-spectrum remote E-Stop switch operates at 2.4GHz using a rechargeable battery pack. The E-Stop switch and receiver/controller unit are connected via Safe Link a continuous monitoring feature exclusive to BASE Engineering.Any loss of signal connection between the remote E-Stop switch and receiver/controller results in an automatic E-Stop trigger until the signal is restored. High powered E-Stop transmitters have an operating range of up to two miles. Transmitters must be connected to a back-up power supply as the battery pack will operate for only seven days. The backup power can be 12/24VDC, 120/240VAC, and solar powered where practical.